Stamping Die

● For the processing of small parts, it is strictly forbidden for the operator's fingers, wrists or other parts of the body to stretch into the mold area for operation.
● The processing of large parts, if the operator has to work in the mold by hand, the range of entering the mold should be reduced as much as possible, and the time for a certain part of the body to stay in the mold should be shortened as much as possible.
● All kinds of parts on the mold should have enough strength and rigidity to prevent damage and deformation during use. The fastening parts should have anti loosening measures to avoid accidental injury to operators.
● It is not allowed to produce waste or workpiece missile phenomenon during the processing process, which will affect the operator's attention or even injure the operator. In addition, the burr of blanking parts should be avoided to cut hands.
● The operator is not allowed to have too large range of action during the stamping operation to avoid losing the stable posture of the body, it is not allowed to have too many and too accurate actions during the operation. Strong noise and vibration should be avoided as far as possible.
● The die weight should be marked on the general drawing for easy installation and safety. Lifting and handling measures should be taken for parts processing above 20kg to reduce labor intensity.
● When assembling and disassembling die parts, it should be convenient and safe to avoid the possibility of clamping and cutting hands; the mould should be easy to disassemble and store.