1. The gap between the slider and the guide rail
The gap between the slider and the guide rail is adjusted mainly for accuracy, and if the adjustment is too tight, it will cause heating. Generally, each side of the small machine is 0.02~0.05mm, and the large machine is 0.03~0.20mm on each side.
2. Comprehensive clearance
Correction method of comprehensive clearance: touch the slider body in motion with your hand during production, and there is a sense of vibration when the slider runs to the bottom dead center, indicating that the comprehensive gap is too large and needs to be adjusted in time.
3. Locking of the slider connecting rod
Due to long-term use or overload, the connecting rod will loosen, and this state is generally considered to be overloaded; In addition, there is oil leaching at the joint site, which may also be overloaded; In this state, the locking degree of the connecting rod lock nut must be adjusted in time, because it is related to safety issues.
4. Maintenance of brake and clutch
The brake and clutch of the stamping machine are important components of the safety of the stamping machine, and it is the cause of major safety accidents, so it is necessary to understand its basic structure, and its safety performance must be confirmed before daily operation, and abnormal conditions (such as: the slider can not stop at the specified position, abnormal sound during operation, abnormal vibration, slow movement of the slider, etc.) and report the maintenance in time.
In addition, maintenance personnel should also pay attention to the performance of excessive clearance between the friction plates of brakes and clutches: the amount of compressed air increases, the slider of the press appears to crawl, and in serious cases, there will be a continuous action of the operation slider, which is absolutely not allowed. Then, if the adjustment gap is too small, the friction plates of the brake and clutch will make friction sounds, heat up, motor current rise, etc., and will also cause damage to the return spring. (Normal clearance standard 1.5~3.0mm).
5. Detachment
The detachment phenomenon generally occurs at the bottom dead center, when the upper and lower molds are closed, resulting in the slider not operating normally. At this time, the motor can be reversed and the pressure of the air compressor can be increased, the operation selection button can be dialed to the "inch" state, and the slider can be pulled up to the top dead center in stages.
6. Correction of bolt loosening
It includes the bolts of the machine tool accessories must be checked regularly, especially some high-speed and frequent stamping machines should be paid attention to, because the vibration of these machine tools is relatively large, and the bolts are easy to loosen. Once the bolt is loosened, if it is not corrected in time, it will cause some unexpected safety accidents.
7. Spot check of oil feeding device
Burns and bites often occur when the oil supply is not timely, so the spot check on the oil supply part must be carried out reliably. It includes oil cups, oil tanks, oil pipes, filters, oil seals, etc., and the phenomenon of "running, rising, dripping, leaking, and blocking" must be dealt with in time.
8. Inspection of compressed air
When there is an air leak in the compressed air pipeline of the machine tool, the pressure will be low, which will affect the operation of the machine tool, and the operation will be defective, so it must be repaired in time.
The moisture content of compressed air should also be controlled (air filtration, drying and dehydration devices can be installed), which is a major cause of slow action and rust in machine tool solenoid valves, cylinders and other devices.
9. Regularly check the accuracy of the stamping machine
The accuracy of the stamping machine will have a direct impact on the service life of the die and the machining accuracy of the product. However, the accuracy of the machine tool of the stamping machine is deteriorated with the extension of time, so it is necessary to carry out regular accuracy checks, and repair the problems in time to ensure that the machine tool has more accurate accuracy, so as to ensure the accuracy of the products produced.
